22 5020 Parts & Specifications Manual Part # 99901218
Parts Information
GENERAL
This section contains the exploded parts drawings and accompanying parts lists for the
assemblies used on this crane. These drawings are intended to be used in conjunction with the
instructions found in the REPAIR section in Volume 1. For optional equipment such as winches
and remote controls, refer to the appropriate service manual.
WARNING
DO NOT ATTEMPT TO REPAIR ANY COMPONENT WITHOUT READING THE
INFORMATION CONTAINED IN THE REPAIR SECTION IN VOLUME 1. PAY PARTICULAR
ATTENTION TO STATEMENTS MARKED WARNING, CAUTION, OR NOTE IN THAT
SECTION. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN
DAMAGE TO THE EQUIPMENT, PERSONAL INJURY, OR DEATH.
CRANE IDENTIFICATION
Every IMT crane has an identification placard (see figure) attached to the mast. When ordering
parts, communicating warranty information, or referring to the unit in correspondence, always
include the serial number and model numbers. All inquiries should be addressed to:
Iowa Mold Tooling Co., Inc.
Box 189, Garner, IA 50438-0189
Telephone: 641-923-3711
Technical Support Fax: 641-923-2424
To Next Page
Loading...
Need help?
General
