10 | Accessories and interfaces INFICON
128 / 152 UL6000-Fab,-PLUS-Operating-instructions-iinc75en1-01-(2206)
Remote control RC1000C and RC1000WL
With the RC1000C remote control you can operate the leak detector over a cable with
a length of up to 28 m.
With the wireless remote control RC1000WL, you can operate the leak detector at a
distance of up to 100 m.
Via remote control you control the functions START, STOP / VENT (STOP/Ventilate),
ZERO (background). The measured leak rate is displayed as a bar graph, as a
numeric value or as a diagram on the display of the remote controls (see the RC1000
Technical Manual).
Measurement values you create over a recording time of up to 24 hours in the internal
memory of the RC1000. You transfer the data easily to a USB flash drive.
You can set an internal setpoint for warning when exceeding the setpoints. The
warning occurs visually on the display and audibly via the built-in loudspeaker or the
connected headset respectively.
The remote controls are placed in robust housings that allow ergonomic operation.
Magnets on the lower side allow installation from horizontal to vertical metal surfaces.
Fig.19: Remote control RC1000WL
Fig.20: Fasten the transmitter with Velcro in a free place
To Next Page
Loading...
