Inficon UL6000 Fab - Fastening Bracket for Sniffer Line SL3000 (Accessory, Optional); Connect Recipient;Test Object to Inlet Flange

INFICON Installation | 5
UL6000-Fab,-PLUS-Operating-instructions-iinc75en1-01-(2206) 47 / 152
5.3 Fastening bracket for sniffer line SL3000
(accessory, optional)
WARNING
Risk of injury due to sniffer tip
When stumbling, for example over lines, the sniffer tip can cause serious injuries,
especially in eye contact.
► To avoid injury from the sniffer tip, align the sniffer tip in the bracket so that it points
away from the operator.
A bracket is available for the sniffer tip. The bracket can be mounted on the back of
the device, see also “Overall device [}20]“.
Scope of delivery (amount):
Bracket (1x), M6 x 12 mm screws (2x) , S6 x 10 x 0.7 mm washers (2x)
1 Mount the bracket as shown using the two screws and washers on the back of
the device.
2 When not in use, align the sniffer line in the bracket so that it points away from
the operator.
5.4 Connect recipient/test object to inlet flange
ü You have 4 ISO K-clamp screws and a wrench with a width across flats of 17 mm.