6 | Operation INFICON
92 / 152 UL6000-Fab,-PLUS-Operating-instructions-iinc75en1-01-(2206)
1 Connect the HDMI cable and the USB cable of the touch monitor with the
connector block of your leak detector, see also “Connections for accessories
and control signals [}31]“. For proper operation, make sure that the cable
length does not exceed 3 m.
2 > Display > Switch monitor
3 Press the "External Monitor" button.
ð The picture will be displayed on the external monitor.
Alternative procedure
► Instead of changing the monitor display, you can connect the external monitor
before switching on the device.
ð Then the picture will be displayed on the external monitor without changing
settings.
6.12.1 Switch back to the internal monitor
NOTICE
Disconnect external monitor
► If the device is turned on, switch to the internal monitor in the menu before
disconnecting the connections of an external monitor.
When the instrument is switched on, you will be able to switch to internal monitor at
any time.
1 > Display > Switch monitor
2 Press the "Internal Monitor" button.
6.13 View vacuum diagram
To check the function and the operating state of the measuring system at a glance,
call up the simplified diagram of the vacuum diagram.
► > Vacuum diagram
To Next Page
Loading...
