5 | Installation INFICON
40 / 152 UL6000-Fab,-PLUS-Operating-instructions-iinc75en1-01-(2206)
WARNING
Fire hazard due to overload, short circuit and overheating
► Observe the permissible ambient conditions.
► Ensure sufficient ventilation, especially on the ventilation slots on the left and right
of the device: There should be free space in the front, to the rear and sides of the
unit of at least 10 cm.
► Do not block the fan inlet in the accessory compartment.
► Keep heat sources away from the device.
► Make sure that the power switch or power plug is always easily accessible.
► Disconnect the device from the mains immediately if smoke is emitted from the
device.
WARNING
Device may fall over due to earthquake
► In areas where there is a risk of earthquakes, secure the device to the device
handle with a short chain or a tension belt (designed for 1100 N).
Fig.7: Handle of the device
CAUTION
Risk of injury due to shortening of the corrugated hose
A corrugated hose connected to the inlet is shortened during evacuation.
► To avoid endangering the stability of the device during evacuation and to prevent
injuries caused by a hose bursting, mount the corrugated hose without mechanical
tension.
► Vent the corrugated hose before loosening.
To Next Page
Loading...
