INIM Electronics SmartLiving 10100L - Page 31

Installation and programming manual
Installation 31
All the functions of the SmartLiving system which use the land line (voice dialler,
answerphone, alarm receiving centre and teleservice) can be managed completely over
the GSM network by the SmartLinkAdv. The SmartLink also allows teleservice
maintenance over the GSM network.
Note If there are ADSL filters on the line, you must connect the control panel downstream of the filters,
to the line dedicated to telephone equipment (this line is clearly indicated on the filters).
If the control panel is not equipped with a SmartLogos30M voice board, voice calls will
produce a continuous beep for 30 seconds.
3-1-7 Connecting to a PC
Programming from a PC requires the SmartLeague software programme (refer to
paragraph 7-3 Programming via the SmartLeague software) and an RS232 serial cable.
Insert the RS232 serial link (accessory item) into the connector [A], as shown in the
figure opposite. If your PC is not equipped with an RS232 port, but has a USB instead,
you can use INIM's approved RS232-USB adapter (accessory item).
3-1-8 Connecting the SmartLogos30M voice
board (accessory item)
The SmartLogos30M voice board provides the SmartLiving system with an array of
useful voice functions.
For proper installation of the board, work carefully through the following steps.
1. Disconnect all power sources to the control panel (mains and lead batteries).
2. Connect the board to the respective connector [B].
3. Power up the system from the mains and reconnect the lead batteries.
Table 3-1: RS232 connector cable
SmartLiving end
DB9F connector
PC end
DB9F connector
23
32
44
55
66
77
88
SmartLiving end
DB9F connector
PC end
DB25F connector
2
2
3
3
4
20
5
7
6
6
7
4
8
5
B
A
9
1
1
9
9
1
1
25