78 Options and programming methods
Anti-intrusion control panels
2. Press to confirm and exit.
The following table shows the voice-message sequence in accordance with the
previously mentioned parameters and options.
Note
If an event is associated with the “Automatic dialer”, the “Type Message” option refers to
messages 261 to 312, that is to say, the messages containing the event descriptions (event
types).
Options
To be activated by keys and :
Class code
This is the CONTACT-ID reporting format Class-Code which corresponds to the event.
Table 7-7:
Event-related messages
“Automatic dialer”
enabled
“Automatic dialer”
disabled
Message type
Plays the message relating to the event type (e.g. “zone
alarm”, “Mains failure”)
This message should not be changed.
You can select any message from 1 to 219
Message A
Blank message, editable
Message B
Contains event details, for events which are not distinctive
(e.g. the “zone alarm” event indicates the zone concerned).
Event Activation
Sequence
1. Message type + 260
2. Message A
3. Message B
4. “Location” (244)
1. Message type
2. Message B
3. “Location” (244)
Sequence in the
event of Restoral
1. “Restoral” (97)
2. Message type
3. Message A
4. Message B
5. “Location” (244)
1. Message A
2. Message B
3. “Location” (244)
Table 7-8:
Event options
Option If enabled If disabled
Event ON to log
When the event occurs, it will be saved to the events log.
When the event occurs, it will not be saved to the events
log.
Event OFF to log
When the event clears, it will be saved to the events log.
When the event clears, it will not be saved to the events
log.
StartPeriodicEv.
When the event occurs, the system will generate Periodic
event number 1.
Silent event
If the event occurs, the system will generate silent calls
which will not be signaled on the keypads.
If the event occurs, the system will generate calls which
will be signaled on the keypads.
Clear call queue
When the event occurs, the system will cancel the outgo-
ing call queue.
Send address
In the case of voice calls, the system will include the
address of the location alarm (refer to the Table 7-7:
Event-related messages)
In the case of voice calls, the system will not include the
address of the location alarm (refer to the Table 7-7:
Event-related messages)
Local Message ON
When the event occurs, the system will play the event-
related voice message on keypad speaker n. 1
Local MessageOFF
When the event occurs, the system will not play the
event-related voice message on keypad speaker n. 1
Automatic Dialer
Refer to the Table 7-7: Event-related messages
Priority
Calls associated with this type of event have priority over
all other calls. Therefore, if a priority event occurs, any
ongoing calls will be interrupted and the priority-event
call will be sent immediately.
Note
This
option is
applicabl
e only
when a
Nexus
device is
installed
ForceAlt.Chann
el
All the programmed event calls will not be made over the
channel indicated by the “Channel” parameter when pro-
gramming each phone number, but instead will be made
over the alternative channel (refer to paragraph 7-10
Telephone).
Automatic SMS
The dispatched SMS message will consist of the event
description in the Events log
The SMS text message can be selected from the 50 mes-
sages provided by the Nexus device. The SMS text mes-
sage is identified by the “SMS message number/index”,
as described below.
Enable SMS
When the event occurs, the control panel will send an
SMS message to all the duly enabled telephone numbers
(refer paragraph 7-10 Telephone)
When the event occurs, the control panel will not send an
SMS message
To Next Page
Loading...
