Name: Intel 100 Series
Brand: Intel
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Intel

Omni-Path Fabric Switches

May 2016 Installation Guide

Doc. No.: H76456Rev 3.0US 61

Omni-Path Switches

2. Get to a [boot]: prompt by following either Step a or b.

a. If the management module is running and displays the -> prompt, type the

following command at the console:

reboot now

and press ENTER.

b. If the module is not running, power on the switch.

3. When the system displays

image1 or image2, press the SPACEBAR to interrupt

the auto load sequence before the counter expires (within 5 seconds).

4. At the

[boot]: prompt type the following:

moduleip <NEW IP ADDRESS>

and press ENTER.

Note: The

moduleip command changes the IP address for image1 and image2 on each

module.

5. At the

[boot]: prompt type reboot, and press ENTER. Following the reboot, the

IP address is changed. Repeat these steps for the second management module.

Questions and Answers:

Need help?

Do you have a question about the Intel 100 Series and is the answer not in the manual?

Intel 100 Series Specifications

General