Intel Omni-Path Switch 100 Series - Page 89

2. At the master MM prompt, enter the following command to update the master and
slave: sftp> put CGBCP429.q7.spkg A:/firmware/bcfw.pkg
The system returns information similar to the following:
Uploading CGBCP429.q7.spkg to /firmware/A:/firmware/bcfw.pkg
CGBCP429.q7.spkg
100% 193KB 11.3MB/s 00:00
You can check the progress of the update with the CLI command
showLastBcFwRetCode -all. The system returns information similar to the
following:
MasterM201-> showLastBcFwRetCode -all
M201 Board Controller Firmware Last Exit Code: 3: In Progress
M202 Board Controller Firmware Last Exit Code: 3: In Progress
MasterM201-> showLastBcFwRetCode -all
M201 Board Controller Firmware Last Exit Code: 0: Success
M202 Board Controller Firmware Last Exit Code: 0: Success
Proceed to Step 3.
3.
Reboot the switch with the command reboot -all.
4. Verify the version of the BCFW and BIOS by running the CLI commands
bcfwversion and biosversion. The system should return information similar to
the following:
Board Controller Firmware Version: CGBCP429
System BIOS Version: QA3ER962
Q7 BIOS Update—Intel
®
Omni-Path Fabric
Intel
®
Omni-Path Fabric Switches Hardware
June 2019 Installation Guide
Doc. No.: H76456, Rev.: 10.0 89