Chapter 2 — Configure Network Settings
32 IF2 Network Reader User Manual
Disable Access Through the Serial Port
When serial port access is disabled, you also disable USB access. When
you disable access, you will not be able to configure the IF2 as
described in “Assign an Initial IP Address” on page 8. You must use
a network application (such as a web browser, SmartSystems Console,
or Device Configuration Web Service application) for all
configuration.
Password Enter the password you need to use to log in to this IF2.
This password gives you read and write access to the IF2
configuration. The password can be from 8 to 32
characters long. You must always specify a password.
Default is intermec.
Read-only
Password
Enter the password you need to use to log in to this IF2.
This password gives the user read-only access to the IF2.
This user can view the configuration and execute
diagnostics but cannot perform any tasks that affect IF2
operation, such as changing configuration options or
upgrading firmware. Default is readonly.
The read-only password cannot be deleted. To disallow
read-only access, you need to enable RADIUS
authentication. For help, see “Configure Security” on
page 26.
Password Parameter Descriptions (continued)
Parameter Description
Note: USB is not supported on the IF2 with Expanded Memory
Option.
To Next Page
Loading...
