Chapter 5 — Manage, Troubleshoot, and Upgrade the IF2
70 IF2 Network Reader User Manual
Use the LEDs to Locate the IF2
You can use the LEDs to help locate a specific IF2 in your location.
To locate an IF2
• In the About This IF2 RFID Reader screen, click Find This
Device. All of the LEDs except the Power and Wired LAN LEDs
flash. Click Finished Finding This Device to turn off the LEDs.
Restore the IF2 to the Default Configuration
There are four ways to restore the default configuration on the IF2:
• You can restore default settings from the web browser interface.
For help, see the next section.
• You can restore default settings by pressing the reset switch
located on the top of the IF2.
• You can restore default settings through a serial connection. For
help, see “To restore defaults with a serial connection” on
page 72.
• You can restore default settings using the Device Configuration
Web Services. For help, see the Device Configuration Web Services
Command Reference Manual.
Note: Restoring default settings as described in this section does not
affect security certificates you have installed.
To Next Page
Loading...
