Chapter 5 — Manage, Troubleshoot, and Upgrade the IF2
80 IF2 Network Reader User Manual
Configure the Firmware Upgrade
The Upgrade Package installer configures IF2 firmware upgrades. The
configuration you need depends on the method you use to upgrade
the IF2:
• Using the web browser interface.
• Using Device Configuration Web Services. For help, see the Device
Configuration Web Services Command Reference Manual.
This section explains how to choose the correct configuration.
To configure the firmware upgrade file
1 Double-click the Upgrade Package utility to run it. The opening
screen appears.
2 Click Next.
3 Click Next to install the upgrade file at the default location, and
then click Install. The upgrade file is installed.
To choose a different location:
a Click Browse to browse to a different location.
b Double-click a folder to choose the location.
c Click Next.
d Click Install. The file is installed at the new location.
4 Click Finish to close the utility.
To Next Page
Loading...
