Chapter 3 — Develop and Use RFID Applications
44 IF2 Network Reader User Manual
Schedule Option
Determines how antennas are switched during the inventory process.
This attribute controls the behavior of the inventory scheduling
parameters.
This setting is equivalent to the SCHEDULOPT BRI attribute.
ID Tries
Sets the maximum number of times the reader executes the identify
algorithm before a response is returned to a Read or Write command.
In practice, this is the number of times a tag ID attempt is made for
each antenna being used. Valid range is 1 to 254 (default is 3).
This setting is equivalent to the IDTRIES BRI attribute.
Antenna Tries
Sets the maximum number of ID Tries that the reader executes per
antenna. Valid range is 1 to 254 (default is 3).
This setting is equivalent to the ANTTRIES BRI attribute.
EPCC1G2 Advance Medium Access Mode
Selects low-level protocol (such as tari and back-link frequency)
settings. If you are using CAEN tags, you must enable this mode
before the tags can be read.
This setting is equivalent to the EPCC1G2PARAMETERS or
EPCC1G2PARMS BRI attribute.
Dense Reader Mode
Allows the reader to hop between channels within a certain frequency
spectrum to prevent other readers in the area from interfering with
one another.
This setting is equivalent to the DENSEREADERMODE or DRM BRI
attribute.
To Next Page
Loading...
