Intermec EasyCoder PD41 User Manual

Chapter 5 — Setting up the Printer
50 EasyCoder PD41 Printer User’s Guide
Press the button > 1 second to perform testfeed. When done, printer
will be ready for use (out of Testfeed mode.)
Extended Testmode: 7e - Exit
Step
Data/
Ready
Error RtW Button Comment
7e1111LEDs flash once per
second.
1 Tap the Print button to exit
Extended Testmode.
The LEDs flash rapidly, and printer is ready for use.
Extended Testmode: 7d - Factory Default Function
Step
Data/
Ready
Error RtW Button Comment

Intermec EasyCoder PD41 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power requirements	100-240 VAC ±10%, 45-65 Hz
Media thickness	2.3 - 9.8 mm
Maximum label width	104 mm
Maximum label length	0.15 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Depth	453 mm
Width	273 mm
Height	270 mm
Weight	13000 g