Appendix C — Setup Parameters (Fingerprint)
EasyCoder PD42 Printer User’s Guide 97
Testprint
The test labels ”Diamonds”, “Chess”, “Bar Codes #1”, and “Bar
Codes #2” are used to check the printout quality and facilitate
adjustment of the printhead pressure, see “Adjusting the Printer”
on page 47. The test labels “Setup Info” and “Hardware Info” list
the printer’s current setup and the installed electronic devices.
Test label “Network Info” is only printed if the printer has an
optional EasyLAN interface board. If the information does not
fit on one label, two or more labels will be printed.
Print Speed
The Print Speed is specified in mm/second. Allowed values are
50-150 mm/s (2-6 ips) for the 203dpi printhead and 50-100
mm/s (2-4 ips) for the 300 dpi printhead. Default is 100 mm/s
(4 ips) and 75 mm/s (3 ips) for 203 and 300 dpi printheads
respectively.
LSS Test
The function on the label stop sensor (LSS) can be tested
automatically or manually as described in “Adjusting the Label
Gap Sensor” on page 53.
Network Setup
Please refer to the EasyLAN User’s Guide (P/N 1-960590-xx) for
information on the network setup parameters.
To Next Page
Loading...
Need help?
General