Appendix A — Specification, Interfaces, and Options
64 EasyCoder PD42 Printer User’s Guide
USB Interface
The printer supports USB v1.1 (also called USB 2.0 full speed).
To use the USB interface to print from a PC, you need to have
the Intermec USB printer driver installed on your PC. You will
find this driver (InterDriver) on the PrinterCompanion CD
along with installation instructions.
The printer is a “self-powered device.” Intermec recommends that
you only connect one printer to each USB port on the host,
either directly or via a hub. Other devices, like a keyboard and a
mouse, can be connected to the same hub. If you need more than
one Intermec USB printer to a host, you should use different
USB ports.
The USB cable included with the EasyCoder PD42 has a USB
Type A connector on one end to connect to a PC, and a USB
Type B connector to connect to the printer.
There is no communication setup for the USB port.
USB Type A Connector (Connects to PC or Hub)
USB Type B Connector (Connects to Printer)
To Next Page
Loading...
