Appendix C — Setup Parameters (Fingerprint)
EasyCoder PD42 Printer User’s Guide 89
• LFASCII 10 dec.
• CRASCII 13 dec.
Receive Buffer
The Receive buffer stores the input data before processing. The
size is 8192 bytes and cannot be changed.
Transmit Buffer
The transmit buffer stores the input data before processing.
Default size is 8192 bytes and this value cannot be changed.
Com Setup
The parameters under the Com node control interface and
external keyboard use.
Interface
If you have an optional Parallel IEEE 1284 interface installed in
the printer, it cannot be used at the same time as the USB Device
interface. In this menu, you can choose which interface is active.
USB Keyboard
You can choose between a number of different keyboard layouts,
that can be applied to an external USB keyboard connected to
the printer through the USB host interface.
Emulation Setup
It is possible to run the PD42 printer as an E4 printer through
software emulation.
Mode
Switch between these options:
• Disabled (default)
•E4
In E4 mode, the following commands are available:
BARFONTSLANT
BARFONTSIZE
FONTDSLANT
FONTDSIZE
FONTD
FONTSLANT
FONTSIZE
To Next Page
Loading...
Need help?
General