Chapter 3 — Configuring the Printer
EasyCoder PD42 Printer User’s Guide 33
The main nodes of the Setup tree (IPL).
Changing Configuration Settings With PrintSet 4
PrintSet 4 is a printer configuration tool which is available on the
PrinterCompanion CD, and for download from the Intermec
website. PrintSet 4 can communicate with your printer either via
a serial cable or a network connection, and works on all PCs
running Windows 98 (or later). The program allows you to easily
change all of the setup parameters. It also includes setup wizards,
which guide you through common configuration tasks.
Changing Configuration Settings From the Printer Home Page
If you have an optional EasyLAN network card and the printer is
connected to your network, you can use your web browser to
browse to the printer home page and make any desired setup
changes there. Follow the instructions provided in “Connecting
the Printer to a Network” on page 11.
Once on the home page, click Configuration on the left side of
the screen to access the setup parameters of the printer.
Changing Configuration Settings Using the Command Line
You can change setup parameters by sending commands directly
to the printer using your terminal program (either through serial
or network connection). The Fingerprint command to use is
SETUP, followed by the node, subnode and parameter setting.
For example, to set your media settings to labels with gaps, send
the following instruction:
SETUP “MEDIA,MEDIA TYPE,LABEL (w GAPS)”
SETUP:
SER-COM
SETUP:
CONFIGURATION
SETUP:
MEDIA
SETUP:
TEST/SERVICE
SETUP:
NETWORK
Option
Starting point
SETUP:
COM
To Next Page
Loading...
Need help?
General