Appendix C — Setup Parameters (Fingerprint)
96 EasyCoder PD42 Printer User’s Guide
Contrast
Use the contrast parameter to make minor adjustments of the
blackness of the printout, for example to adapt the printer to
variations in quality between different batches of the same media.
The options are values between -10% to 10% in steps of 2.
Default value is 0%. The contrast is reset to the default value
whenever a new paper type is specified, regardless which method
has been used.
Testfeed
The Testfeed is a read-only parameter that indicates internal
parameters for the Label Stop Sensor. These are automatically set
when running a Testfeed. It is very important to run a testfeed
when switching from one media type to another.
Testfeed Mode
In certain unusual cases, a Testfeed may have been unable to
succesfully identify gaps or marks in the media. It is thus possible
to set the Testfeed mode to Slow to allow the Label Stop Sensor
to more easily identify media gaps/marks. The options are Slow
and Fast (default).
LEN (Slow Mode)
When the Testfeed mode is set to slow, the printer will sample the
media length plus 10mm. You can change the sample length by
specifying the number of dots in LEN(Slow Mode), the
minimum being the number of dots corresponding to 10mm.
The default (media length plus 10 mm) is specified by the value
0.
Print Defs Setup
Clip default
The Clip Default parameter determines whether text, bar codes,
images, lines and box fields that extend outside the print window
(see page 93) should be printed or not.
• OFF (default). If any objects are found to extend outside the
print window, printing will be stopped and error 1003 “Field
out of label” is issued.
• ON. This disables Error 1003, and partial objects can be
printed.
To Next Page
Loading...
Need help?
General