Intermec EasyCoder PD42 User Manual

Appendix C — Setup Parameters (Fingerprint)
EasyCoder PD42 Printer User’s Guide 95
The following table gives initial recommendations for suitable
settings.
Use the above settings as initial settings and adjust the Label
Constant if necessary.
Thermal Transfer printing
• Ribbon Constant (range 50 to 115). Default is 90.
• Ribbon Factor (range 10 to 50). Default is 25.
• Label Offset (range -50 to 50). Default is 0.
The following tables gives initial recommendations for suitable
settings.
The receiving material has been excluded from this table, since
the ribbon has the largest impact for heat settings for thermal
transfer settings.
Use the above settings as initial values, and adjust the Ribbon
Constant if necessary.
Direct Thermal Recommmended Settings
Paper
sensitivity
Label
Constant
Label
Factor
Max Print
Speed (203
dpi
Max Print
Speed (300
dpi)
Low 100 40 75 50
Standard 90 40 100 75
High 80 40 125 100
Ultra High 70 40 150 100
Thermal Transfer Recommended Settings
Ribbon
Ribbon
Constant
Ribbon
Factor
Max Print
Speed (203
dpi
Max Print
Speed (300
dpi)
Wax80207575
Hybrid
(Wax/Resin)
90 25 100-150 75-100
Resin 100 30 150 100

Intermec EasyCoder PD42 Specifications

General

Brand	Intermec
Model	EasyCoder PD42
Category	Printer
Language	English