Chapter 3 — Configuring the Printer
34 EasyCoder PD42 Printer User’s Guide
The corresponding instruction in IPL is:
<STX><SI>T1<ETX>
Hyperterminal settings (IPL only)
For more information on how to change setup parameters, see
the Fingerprint Programmer’s Reference Manual (P/N 937-005-
xxx), or the IPL Programmer’s Reference Manual (P/N 066396-
xxx).
Running Testmode and Extended Testmode
Use Testmode and Extended testmode when you want to verify
printer settings, print test labels, restore factory default settings,
or enter Dumpmode for troubleshooting purposes. Two
testmodes are available, Testmode and Extended Testmode.
Testmode is a simple linear sequence which requires little input,
while Extended Testmode gives the user more options.
Running Testmode
Testmode performs the following sequence:
1 Select media type (gaps/mark/continuous).
Note: IPL users should first verify that they have the
correct HyperTerminal settings. See the screen capture
below.
To Next Page
Loading...
Need help?
General