Appendix A — Specification, Interfaces, and Options
EasyCoder PD42 Printer User’s Guide 67
Parallel IEEE 1284 Interface
This kit adds a Parallel IEEE 1284 port to your printer. See
“Parallel IEEE 1284 Interface” on page 66.
Cutter Kit
The cutter is designed to cut off continuous paper-based stock or
liner between labels. The paper cutter can be controlled using the
instructions CUT, CUT ON and CUT OFF in Fingerprint (and
Direct Protocol).
Internal Rewinder
The Internal Rewinder (and Batch Takeup) kit is an optional
device for peel-off (self-strip) operation, which means that the
labels are separated from the liner (backing paper) after printing
and the liner is wound up on an internal hub (See “Loading
Media for Peel-Off (Self-Strip) Operation” on page 17.). It can
also be used to roll up complete batches of label rolls. The unit
also includes a guide shaft.
Printhead Kit
The printer can be fitted with either a 203 dpi or 300 dpi
printhead. These printheads use different PCBs (Printed Circuit
Board). The printhead kit is available as a replacement kit
(printhead only), or as a complete kit (printhead plus PCB).
Real Time Clock
The Real time clock circuit (RTC) relieves the operator or the
host from having to set the clock/calendar using the Intermec
Fingerprint instructions DATE$ and TIME$ after each power
up. The RTC has its own backup battery that will last 10 years or
more.
To Next Page
Loading...
Need help?
General