Appendix D — Setup Parameters (IPL)
EasyCoder PD42 Printer User’s Guide 111
The sensitivity number on each roll of thermal transfer media or
ribbon has an asterisk (*) in place of one of the digits. To
optimize the sensitivity number for thermal transfer media, you
combine the digits as in this example.
The media sensitivity number can also be changed using
PrintSet, the printer’s home page, third-party software, or an IPL
command with the following syntax:
<STX><SI>gn[,m]<ETX>
where:
n specifies direct thermal(n=0) or thermal transfer(n=1)
media.
m specifies the sensitivity.
The default sensitivity number is 420 for direct thermal printing
and 567 for thermal transfer printing.
To find heat settings for different ribbon and media (North America)
1 Go to www.intermec.com.
2 Navigate to Products > Printers > Printers Fixed >
EasyCoder PD42.
3 Scroll to the bottom of the page and click PD41/PD42 Heat
Settings (PDF).
Users outside the U.S.A. and Canada should visit the Intermec
regional website, or contact their Intermec sales representative.
Media or Ribbon
Sensitivity
Rating
Description
Thermal transfer media
56*
The asterisk for the third digit
is reserved to identify the
ribbon’s sensitivity number.
Thermal transfer ribbon
5*7
The asterisk for the second
digit is reserved to identify the
media’s sensitivity number.
=567
Optimum sensitivity rating
To Next Page
Loading...
Need help?
General