Chapter 2 — Installing the Printer
20 EasyCoder PD42 Printer User’s Guide
The EasyCoder PD42 can use transfer ribbon rolls wound with
the ink-coated side facing either outward or inward. To
determine which type of ribbon you have, use a pen or another
sharp object to scratch through the ribbon against a piece of
paper. If it leaves a mark, your ribbon is wound ink in or ink out
according to the following model.
Test to determine whether your transfer ribbon is wound ink-in or ink-out.
To load thermal transfer ribbon
1 Open the side door of the printer.
2 Pull out the printhead lever (1) and turn it counterclockwise
(2) to raise the printhead.
= Ink out
= Ink in
2
1
To Next Page
Loading...
Need help?
General