Chapter 4 — Managing, Troubleshooting, and Upgrading the IF61
86 IF61 Fixed Reader User’s Manual
SNMP Trap Target 2 Authoritative name for trap target 2.
SNMPv3 Username
(Read-Only)
User name for SNMPv3 read-only access.
Default is
readonly.
SNMPv3 Password
(Read-Only)
Password for SNMPv3 read-only access.
Default is
intermec.
SNMPv3
Authentication Type
(Read-Only)
Specifies the protocol for encrypted SNMPv3
messages. This must match a supported
encryption protocol on the SNMP
management station. Choose MD5, SHA1
(default), or None.
SNMPv3 Privacy Type
(Read-Only)
Specifies the protocol for read-only access to
encrypted SNMPv3 messages. Must match a
supported protocol on the SNMP
management station. Choose DES, AES (128
bit), or None. Default is AES (128 bit).
SNMPv3 Username
(Read/Write)
User name for SNMPv3 read/write access.
Default is
intermec.
SNMPv3 Password
(Read/Write)
Password for SNMPv3 read/write access.
Default is
intermec.
SNMPv3
Authentication Type
(Read/Write)
Specifies the protocol for encrypted SNMPv3
messages. This must match a supported
encryption protocol on the SNMP
management station. Choose MD5, SHA1
(default), or None.
SNMPv3 Privacy Type
(Read/Write)
Specifies the protocol for read/write access to
encrypted SNMPv3 messages. Must match a
supported protocol on the SNMP
management station. Choose DES, AES (128
bit), or None. Default is AES (128 bit).
SNMP Community Parameter Descriptions (continued)
Parameter Description
To Next Page
Loading...
