Chapter 1 — Learning About the SR61T
SR61T Tethered Scanner User’s Guide 5
You can change the beep volume for your needs and environment.
You can set the beep volume to Low (quiet), Medium (loud), or High
(very loud - default).
To turn off the beeper
• Scan this bar code:
Beep Duration - 0
\60\03\11\21\00\00\00
You can also change the beeper duration and beeper frequency. For
more information about the beeper commands, see Chapter 4,
“Configuration Command Reference.”
Using Vibrate Alert
In the default scanner mode, you can configure the SR61T to vibrate
when it successfully decodes a bar code. This feature can be useful in
these situations:
• You are in a noisy environment, such as a busy warehouse, where it
can be difficult to hear the beep.
• You are working in a quiet environment, such as a library, where
you do not want to make a lot of noise.
Note: The SR61TV (linear imager) and SR61TL (laser scanner) may
also produce a crackle sound when you scan a stacked (2D) bar code.
For more information, see “Stacked Code Crackle” on page 54.
To Next Page
Loading...
Need help?
General
