Chapter 2 — Connecting and Configuring the SR61T
20 SR61T Tethered Scanner User’s Guide
IBM/NCR Terminals
\60\02\53\20\00\1D\20
Serial Parameter Parameters
If your SR61T is connected to a host with an RS-232 cable, configure
your SR61T serial parameters to match the host. This section
contains bar codes for basic serial parameters. To configure additional
serial parameters, use EasySet.
* = default
Baud Rate
1200
\60\02\48\40\00\0A\40
2400
\60\02\48\40\00\0A\40
4800
\60\02\48\40\00\10\00
9600
\60\02\48\40\00\12\40
Note: By default, RTS/CTS hardware protocol is disabled. To enable
this parameter, use EasySet version 5.6.0.1 or later. RTS/CTS hardware
protocol operates only in one direction. The SR61T requests
permission from the host to transmit and monitors host
transmissions.
To Next Page
Loading...
Need help?
General
