Chapter 2 — Connecting and Configuring the SR61T
22 SR61T Tethered Scanner User’s Guide
Odd
\60\02\48\43\00\05\20
Stop Bits
1*
\60\02\48\44\00\00\00
2
\60\02\48\44\00\02\40
Enabling the Configurable RS-232 Protocol
By default, the SR61T uses ISCP to communicate with a host
computer. If you are connecting the SR61T to a host computer, for
example an Intermec Terminal that speaks ISCP, you will not need to
do anything.
If you are connecting your host computer that does not use ISCP, you
must disable the ISCP protocol, that is, enable the Configurable RS-
232 protocol.
You may also want to configure the ENQ, ACK, NAK, and LRC
parameters. For more details about the Configurable RS-232
Protocol, see “Understanding Features of Configurable RS-232
Protocol” on page 23.
If you are connecting to a Intermec Terminal using ISCP or EasySet,
keep the default settings for Data bits, Parity and Stop bits so ISCP
can work properly.
To Next Page
Loading...
Need help?
General
