Chapter 4 — Configuration Command Reference
48 SR61T Tethered Scanner User’s Guide
Good Read Beep Duration
Sets the length of the SR61T good read beeps. You can set Good Read
Beep Duration to a value from 0 (off) to 2550 ms.
Use Good Read Beep Duration in combination with Beep Volume and
Beep Frequency to define beeps according to operator preference and
work environment.
Good Read Beep Number
Establishes the number of beeps used for the good read beep: one,
two, or none.
Good Read Beep Timing
Sets the good read beep to occur either before or after successfully
transmitting data.
Good Read LED Duration
Sets the amount of time the green Status light stays on after a good
read. You can set Good Read LED Duration to a value from 0 (off) to
5110 ms. When the Status light is on due to a long duration setting,
the SR61T can still read new bar codes and receive commands.
GS1 Composite
Enables or disables GS1 Composite symbology. A GS1 Composite
symbol consists of a linear component (encoding the item’s primary
identification) associated with an adjacent 2D Composite
Component (encoding supplementary data, such as a batch number
or expiration date). The Composite symbol always includes a linear
component to ensure that the primary identification is readable by all
scanning technologies, and so that 2D imagers can use the linear
component as a finder pattern for the adjacent 2D Composite
Component.
To Next Page
Loading...
Need help?
General
