Chapter 4 — Configuration Command Reference
SR61T Tethered Scanner User’s Guide 41
Alt Mode
A data transmission settings that allow the SR61T to transmit special
characters to a host computer. For example, if Alt mode is enabled,
the character “Alt+ 0196” is interpreted as “Ä.” When Alt mode is
disabled, “Alt+0196” is transmitted as is.
Australian Post
SR61TA (area imager) and SR61TE (near-far range area imager) only.
Enables or disables decoding of Australian Post symbology.
Australian Post is a 4-state bar code that allows Australian Post to sort
incoming mail using a bar code. There are three types of bar codes
corresponding to FCC values 11, 59, and 62. BarDIMM only needs the
DPID and Customer information, and automatically generates all the
other information like the FCC or Reed-Solomon checksum.
Aztec
SR61TA (area imager) and SR61TE (near-far range area imager) only.
Enables or disables decoding of Aztec symbology. Aztec is a 2D matrix
symbology made up of square modules on a square grid, with a square
bulls eye pattern at their center. Aztec Code symbols can encode large
amounts of data with user-defined error-correction level.
Baud Rate
Sets the baud rate for the communications. The baud rate must
match the baud rate of the host. You can set Baud Rate to a value of
1200, 2400, 9600, 19200, 38400, 57600, or 115200.
Beep and LED Mode
Sets the way in which the beeps and LED lights will behave on the
SR61T. By default, the scanner is set to behave in one way, but it can
be configured to operate differently.
Beep Duration
Sets the length of the beeps. You can set Beep Duration to a value
from 0 to 2550 ms. When Beep Duration is set to 0 ms, the beeper is
off.
To Next Page
Loading...
Need help?
General
