Chapter 4 — Configuration Command Reference
42 SR61T Tethered Scanner User’s Guide
Use Beep Duration in combination with Beep Frequency and Beep
Volume to define beeps according to operator preference and work
environment.
Beep Frequency
Sets the frequency, or pitch, of the beeps. You can set Beep Frequency
to a value from 1000 to 5110 Hz.
Use Beep Frequency in combination with Beep Volume and Good
Read Beep Duration to define beeps according to operator preference
and work environment.
Beep Volume
Adjusts the volume of the beeps. You can set Beep Volume to Low,
Medium, or High.
Use Beep Volume in combination with Beep Frequency and Good
Read Beep Duration to define beeps according to operator preference
and work environment.
BPO
SR61TA (area imager) and SR61TE (near-far range area imager) only.
Enables or disables decoding of BPO (British Post Office) 4-state bar
code symbology. BPO was developed by the British Post office for
encoding European postcode data similar to the way the U.S. Postnet
symbology is used for encoding Zip Code data. BPO provides
European countries with a simple and efficient postal bar coding
scheme.
Canada Post
SR61TA (area imager) and SR61TE (near-far range area imager) only.
Enables or disables decoding of Canada Post 4-state bar code
symbology. Canada Post contains addressing as well as customer-
specific information. Canada Post sends mail pieces through Canada
Post’s integrated distribution system in the most cost-efficient way.
Note: To turn off the beeper, set the Beep Duration to 0.
To Next Page
Loading...
Need help?
General
