Chapter 4 — Configuration Command Reference
SR61T Tethered Scanner User’s Guide 55
Symbology Identifier
Symbology identifiers allow you to indicate the type of data being
sent by prepending an identifier. You can prepend one of the
following types of character strings to identify which symbology the
data is using.
Telepen
Enables or disables decoding of Telepen symbology. Telepen is the
only symbology to directly represent the full ASCII character set
without shift characters. Considered extremely secure, Telepen has
negligible risk of misreads and a double-density numeric only mode.
Timeout Between Different Consecutive Codes
This command prevents the scanner from decoding unwanted bar
codes on the same label. The scanner invalidates a second bar code
read if it occurs before the timeout expires. Use this command when
consecutively scanning bar codes that contain different data, as
opposed to the Timeout Between Identical Consecutive Codes
command.
You can set Timeout Between Different Consecutive Codes to a value
from 0 to 2550 ms.
Symbology Identifier Options
Character String Descriptions
AIM identifier The AIM Standard for symbology identifiers consists
of a three-character structure indicating the symbology
and the optional features of the symbology. For more
information about the AIM Standard for symbology
identifiers, refer to the AIM ISO/IEC Standard.
User-defined
symbology
identifier (UDSI)
The user-defined symbology identifier (UDSI) is one to
four ASCII characters in length. You can configure
user-defined symbology identifiers to assign custom
identifier strings to the bar code symbologies.
Code mark Enables the code mark symbology identifier for all
symbologies.
To Next Page
Loading...
Need help?
General
