Intermec SR61T User Manual

Chapter 3 — Troubleshooting and Maintaining the SR61T
30 SR61T Tethered Scanner User’s Guide
Resetting the SR61T
If your SR61T does not respond when you pull the trigger, you can
reset your SR61T. When you send the Administrator Reset Factory
Defaults command, the configuration command parameters are
returned to their original factory defaults and the scanner restarts.
To reset your SR61T
1 Establish a connection with EasySet.
2 Send the Administrator Reset Factory Defaults command to the
SR61T.
Maintaining the SR61T
To keep your SR61T in good working order, you may need to upgrade
the SR61T and clean the scanner window.
You scan a
configuration bar code
and the SR61T beeps
three times.
The SR61T does not recognize or support the
configuration bar code you scanned.
You scan a bar code, the
SR61T beeps once, and
the status light blinks
green once, but the data
is not transmitted to the
host computer.
Try these possible solutions:
• Make sure that your data collection
application is set up to receive data from the
SR61T.
• If you are using an RS-232 cable, make sure
that the serial parameters on the SR61T match
the serial parameters of the host computer. The
default serial parameters for the SR61T are:
57600 baud, 8 data bits, no parity, and 1 stop
bit.
You scan a data bar code
and the scanner beeps
once, pauses for half a
second, and then beeps
three times.
Try disconnecting and then reconnecting the
scanner to the host and then reestablish
communications with the host.
Problems and Possible Solutions (continued)
Problem Possible Solution

Intermec SR61T Specifications

General

Brand	Intermec
Model	SR61T
Category	Barcode Reader
Language	English