Intermec SR61T - Scanning Bar Codes

Chapter 1 — Learning About the SR61T
6 SR61T Tethered Scanner User’s Guide
To turn on vibrate alert
• Scan this bar code:
Turn On Vibrate Alert
\60\03\10\48\00\02\40
To turn off vibrate alert
• Scan this bar code:
Turn Off Vibrate Alert
\60\03\10\48\00\00\00
Scanning Bar Codes
The SR61T contains either a 1D linear imager (SR61TV), 2D area
imager (SR61TA), laser scan engine (SR61TL), or near-far range area
imager (SR61TE) to scan bar code data. The type of scan engine you
are using and the type of bar code you are decoding determines the
way you scan the bar code.
When you unpack the SR61T, these bar code symbologies are enabled:
• Code 39
• Code 128 / GS1-128
Note: You cannot configure the SR61T to vibrate when it is
configured to behave in the Legacy scanner mode.
For the SR61TL and SR61TE, do not look directly into the
window area or at a reflection of the laser beam or laser aiming
beam while the laser is scanning. Long-term exposure to the laser
beam can damage your vision.