Intermec SR61T User Manual

Chapter 4 — Configuration Command Reference
36 SR61T Tethered Scanner User’s Guide
Using Configuration Commands
A configuration command changes the way the SR61T operates. For
example, you can change the Beep Volume and make the SR61T
beeper very quietly.
You can configure the SR61T:
• by sending commands to your SR61T from your PC using EasySet.
• by sending commands to a bar code setup sheet. Then, scan the
bar codes onscreen with your SR61T (SR61TE or SR61TA only), or
print the setup sheet and scan the bar codes.
• by sending commands to your SR61T from your Intermec
computer using Intermec Settings.
For a list of all the commands and their default values as they are
organized in EasySet, see the next section, “Configuration
Commands By Function.”
For descriptions of each command organized alphabetically, see
“SR61T Configuration Commands” on page 40.
Configuration Commands By Function
The configuration commands are grouped by function and reflect the
organization of the Commands window in EasySet.
Note: When you first connect to an Intermec computer, only
SR61T settings common to the Intermec computer’s internal
scanner settings are changed to the internal scanner’s default
settings.
Reset All Parameters
Command Default Value See Page
Administrator reset factory defaults N/A 40

Intermec SR61T Specifications

General

Brand	Intermec
Model	SR61T
Category	Barcode Reader
Language	English