Appendix — Specifications and Accessories
SR61T Tethered Scanner User’s Guide 75
To return the SR61T to its default behavior
• Scan the following bar code
\60\03\10\4C\00\00\00
The following table describes the lights when SR61T is in Legacy
mode.
The following table describes the beeps when SR61T is in Legacy
scanner mode.
Legacy Scanner SR61T Light Descriptions
Light State What it Means
Blinks green once The SR61T successfully decoded a bar code and
sent the data to the host computer.
The SR61T successfully scanned a configuration
bar code.
Turns on and stays
red for 2 seconds
You scanned a bar code, but the data was not sent to
the host computer.
You scanned a configuration bar code and the
SR61T did not accept it.
Legacy Scanner SR61T Beep Descriptions
Beep Sequence What it Means
Single beep The SR61T successfully decoded a bar code or
scanned a configuration bar code.
Six beeps Data was not successfully sent to the host
computer. A configuration bar code was not
successfully scanned.
Two beeps The SR61T is starting up.
To Next Page
Loading...
Need help?
General
