Interroll MultiControl
Appendix
Version 2.3 (01/2017) en-US
Translation of original instruction manual
59
No. Short text Comment
27 ApplErrNbrHandShake Error in neighborhood communication:
No response received to handshake message
28 ApplErrNbrLifeCheck Error in neighborhood communication:
No life signal received from neighbor
30 ApplErrErrorDataUpdate Access error to error data
31 ApplErrErrorLogUpdate Access error to error log file
40 ApplErrPanelIllMode Mode change not allowed
41 ApplErrPanelLedBlocked Access to LED control blocked
42 ApplErrInvalidApplConf Invalid configuration of application program
50 ApplErrDriveError1 Error RollerDrive 1
51 ApplErrDriveError2 Error RollerDrive 2
52 ApplErrDriveError3 Error RollerDrive 3
53 ApplErrDriveError4 Error RollerDrive 4
60 ApplErrStateTable Error in application program
61 ApplErrCtrlError1 Specific error of application program. The errors of
the ZPA / ZPA+ programs are explained in the
respective instructions.
62 ApplErrCtrlError2
63 ApplErrCtrlError3
64 ApplErrCtrlError4
65 ApplErrCtrlError5
66 ApplErrCtrlError6
67 ApplErrCtrlError7
68 ApplErrCtrlError8
69 ApplErrStartProgram Start of application program not possible
70 ApplErrSysRestart (Re)Start of application program / system
71 ApplErrPowerFail Voltage error: Breakdown of supply voltage
90 ApplErrTemperature Temperature error:
Temperature at brake chopper resistor too high
91 ApplErrLowVoltage Voltage error: Supply voltage (L1 or L2) too low
92 ApplErrHighVoltage Voltage error: Supply voltage (L1 or L2) too high
93 ApplErrMotorVoltage Voltage error: Motor voltage missing
94 ApplErrOvcOverloaded Overload of brake chopper resistor
101 ApplErrInvalidStateTblConf Error loading application program
102 ApplErrNewStateTable New application program loaded
103 ApplErrInvalidErrConf Invalid configuration for the selected application
program
104 ApplErrInvalidTeachParams Invalid parameters for teach-in procedure
To Next Page
Loading...
Need help?
General
