Interroll MultiControl
Safety
Version 2.3 (01/2017) en-US
Translation of original instruction manual
9
Interfaces to other devices
By assembling the MultiControl in a conveyor module, potential hazards may occur. These are
not part of this manual and have to be analyzed during the design, installation and startup of
the complete system.
4 After assembling the MultiControl in a conveyor module, check the whole system for a new
potential dangerous spot before switching on the conveyor.
4 Additional constructive measures may be required.
Operating modes
Normal mode
Operation of the installed device at the end customer's as a component in a conveyor in a
complete system.
Special mode
Special operation refers to all operating modes which are required to guarantee and maintain
regular operation.
Special operating mode Explanation Comment
Transport/storage Loading and unloading, transport and storage -
Assembly/Initial start-up Installation at the end customer and performing the test run -
Cleaning External cleaning without removing protective devices In the de-energized state
Maintenance/Repairs Maintenance and inspection tasks In the de-energized state
Troubleshooting Troubleshooting in the event of a fault -
Fault elimination Eliminating the fault In the de-energized state
Decommissioning Removing from the complete system In the de-energized state
Disposal Removing from the complete system and disassembly In the de-energized state
To Next Page
Loading...
Need help?
General
