Interroll MultiControl
Safety
8 Version 2.3 (01/2017) en-US
Translation of original instruction manual
Dangers
The following list provides information about the various types of danger or damage that may
occur while working with the MultiControl.
Bodily injury
4 Work on the device must be performed only by authorized qualified persons in accordance
with the applicable regulations.
4 Before using the MultiControl, ensure that no unauthorized personnel is in the vicinity of the
conveyor.
Electricity
4 Only perform installation and maintenance work in the de-energized state.
4 Secure the device against inadvertent activation.
Working environment
4 Do not use the MultiControl in areas where there is a hazard of explosion.
4 Remove material that is not required and unnecessary objects from the workspace.
Faults during operation
4 Regularly inspect the MultiControl for visible damage.
4 If you notice smoke, switch off the power immediately and ensure that it cannot be switched
on again accidentally.
4 Immediately contact a qualified person and have the person determine the cause of the fault.
Maintenance
4 Because the product does not require maintenance, you only need to inspect the
MultiControl regularly for visible damage and that all cables and screws are firmly in place.
Accidental motor start
4 Ensure that a connected motor cannot start accidentally, particularly for assembly,
maintenance work and troubleshooting.
To Next Page
Loading...
Need help?
General
