IPE300 series engineering VFD Function parameter list
-173-
ACC/DEC
time of steps
0–7 of simple
PLC
The description is as follows:
Select corresponding acceleration/deceleration
time, and then convert 16-bit binary number into
hexadecimal number, finally, and then set
corresponding function codes.
ACC/DEC time 1 is set by P00.11 and P00.12;
ACC/DEC time 2 is set by P08.00 and P08.01;
ACC/DEC time 3 is set by P08.02 and P08.03;
ACC/DEC time 4 is set by P08.04 and P08.05.
Setting range: 0x0000–0xFFFF
ACC/DEC
time of steps
8–15 of
simple PLC
0: Restart from the first step, namely if the VFD
stops during running (caused by stop command,
fault or power down), it will run from the first step
after restart.
1: Continue running from the step frequency
when interruption occurred, namely if the VFD
stops during running (caused by stop command
To Next Page
Loading...
Need help?
General