EasyManua.ls Logo

ISCO 6700SR - Page 5

ISCO 6700SR
190 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6700SR Refrigerated Sampler
SAFETY SUMMARY
The Model 6700SR Refrigerated Sampler is a “defi-
nite purpose” device, intended for use only with
compatible Isco equipment. Do not use this prod-
uct with any other manufacturers’ equipment, or
for any other purpose. Use for any purpose not
described in this manual could cause personal
injury or property damage.
Electrical Requirements
The refrigerator is available in both 120 V and
230 V configurations. The required operating
voltage for the refrigerator is listed on the Identifi-
cation and Serial Number label, placed on the
inside of the sample compartment door.
Refrigerators configured for 120 V operation are
equipped with a North American NEMA 5-15P
plug and is intended for use only with 120 V , 60
Hz. The power source should be rated for 30
ampere service.
Refrigerators configured for 230 V operation are
equipped with a Continental European CEE 7/7
plug and is intended for use only with 230 V , 50/
60 Hz. The power source should be rated for 16
ampere service.
Refrigerators in either configuration provide 12.5
V at 5 amperes for the sampler controller. This
output is from the two-pin military-type connector
on the cord on top of the refrigerator. This output is
intended for 6700 Series Sampler controllers only.
The refrigerator must be installed near a
suitable power outlet. Never use an
extension cord.
The power outlet must be visible and eas-
ily accessible. Unplugging the refrigerator
is the only means of disconnecting power.
To minimize the risk of electrical shock,
the refrigerator must be connected to an
outlet with an electrical ground contact.
The power source must be a dedicated
circuit. The line must not power any
other devices.
Never operate the refrigerator with the
lower front or rear panels removed.
Never operate the refrigerator in an
explosive atmosphere.
Do not lift or carry the refrigerator. Use
an appliance carrying device.
Fuses must be replaced with the required
size, current, voltage, and blow-time spec-
ifications. Refer to the Replacement Parts
Listing for the correct part number.
SAFETY SYMBOLS AND HAZARD ALERTS
The icons on the Model 6700SR Refrigerated Sam-
pler and those found within this instruction man-
ual alert the user of known hazards. The icons are
described below.
This icon identifies a general hazard.
Refer to the instruction manual for more
information.
This icon indicates the risk of electrical
shock. Refer to the instruction manual
for more information.
The instruction manual identifies the hazardous
condition and any steps necessary to correct the
condition. The manual presents this information in
one of two ways:
Cautions identify a potential hazard, which if not
avoided, may result in minor or moderate injury. This
category can also warn you of unsafe practices, or
conditions that may cause property damage.
Warnings identify a potentially hazardous condi-
tion, which if not avoided, could result in death or
serious injury.
CAUTION
WARNING

Table of Contents