123
CHAPTER 10. MOWER DECK
Assembled side metal (support)
Fig. 10-7
3.2.2. DISASSEMBLY AND REASSEMBLY
Disassemble, inspect, and reassemble the supports in accordance with the following insturctions, refer-
ring to the drawing above.
- Inspect the oil seals for wear and deformation. (Oil seals are fundamentally consumable parts, so disas-
semble ones should be replaced with new ones.)
- When installing an oil seal, take care not to allow the lips of the oil seal to turn up or the oil seal to be
installed slanted.
- Inspect the bearings for wear or abnormal noise and replace defective ones.
- After reassembly, make sure the shafts turn smoothly.
- After reassembly, apply sufficient grease to lubrication points.