16
SERVICE MANUAL FOR SGR19 & SGR17
Note:
Keep on pushing the engine forward while lift-
ing it up to avoid damaging the radiator shroud
and cooling fan.
REINSTALLATION
Note:
Reassemble in reverse order of disassembly. But
check every part and replace defective ones.
(1) Install the engine on the frame.
– Install both insulators so that they are bent
slightly outwards.
Note:
– The bolts which tighten the insulators on the
frame should be loosened in advance.
– Install both stoppers so that there is a clearance
of 1.5 to 4.5 mm on both sides in the engine
bracket.
– The engine should not be slanted either to the
right or to the left.
(2) Install the front PTO and related parts.
– Install the PTO pulley and shaft.
– Set the belt and tension pulley.
– Install the stopper and cover.
(3) Install the drive shaft.
(4) Install fuel pipes.
– Install the pipes on the injection pump.
– Install the fuel return pipes on the nozzles.
(5) Connect wire harness.
– Glow plug terminals
– Thermometer
– Oil pressure switch
– Starter
– Alternator
– Fuel cut-off unit
(6) Install radiator hoses.
(7) Install the air intake pipe, throttle wire, tension
arm wire, etc., and then check that they have been
installed securely.
– The front PTO clutch control wire should be
connected with the tension spring through the
wire holder and the hole at the right-hand bot-
tom of the steering post.
Fig. 2-21
PTO
ON
0.2 to
0.3 mm
To Next Page
Loading...
Need help?
General
