(5) Removal of the rocker shaft assembly (Fig. 3-20).
(6) Removal of the push rods.
(7) Removal of the water by-pass hose.
(8) Removal of nozzles.
Fig. 3-22
• Remove the cap.
• Remove fuel-return pipes.
• Draw out the nozzle along with the gasket.
Note:
Be careful to keep the nozzle free from dust.
(9) Removal of glow plugs.
(10) Removal of the cylinder head.
• Loosen the cylinder head bolts in the sequence
shown in the figure.
• After the removal of the cylinder head, remove
the dowels and tappets.
Fig. 3-23
1. REMOVAL OF THE CYLINDER HEAD
(1) Removal of the cylinder head cover.
Fig. 3-19
(2) Disconnection of the injection piping.
• When the piping has been removed, cap the de-
livery pipe holders, injection nozzles and injec-
tion pipes at once to avoid dust.
Fig. 3-20
(3) Removal of the fan belt.
(4) Removal of the oil pipe.
Fig. 3-21
To Next Page
