ITech IT6500C Series

Calibration Command
Copyright© Itech Electronics Co., Ltd. 102
Command syntax
CALibrate:EQUal:OUTPut:CURRent[:DATA] <NRf>
Arguments
NRf
Unit
A
Example
CAL:EQU:OUTP:CURR 12.0
CALibrate:SUMMary:OUTPut:CURRent:LEVel
This command is used to set calibration point of summary current.
Command syntax:
CAL:SUMM:OUTPut:CURRent:LEVel <P0|P1>
Arguments
P0|P1
Example
CAL:SUMM:OUTP:CURR:LEV P0
CALibrate:SUMMary:OUTPut:CURRent[:DATA]
This command is used to set calibration data of summary current.
Command syntax
CALibrate:SUMMary:OUTPut:CURRent[:DATA] <NRf>
Arguments
NRf
Unit
A
Example
CAL:SUMM:OUTP:CURR 20.0
CALibrate:SAVe
This command is used to save the calibration parameters in a nonvolatile
memory.