ITech IT6500C Series

Output Commands
Copyright© Itech Electronics Co., Ltd. 29
Chapter7 Output Commands
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude]
This command is used to set the output current value.
Command syntax
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude]<MINimum|MAXimum|N
Rf>
Arguments
MINimum|MAXimum|NRf
Unit
A
Reset Value
0.5 (The reset value of different models are different)
Example
CURR 2.0
Query syntax
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude]? [MINimum|MAXimum]
Returns
NRf
[SOURce:]CURRent:MINimum[:LEVel]
This command is used to set the minimum value of current.
Command syntax
[SOURce:]CURRent:MINimum[:LEVel] <MINimum|MAXimum|NRf>
Arguments
MINimum|MAXimum|NRf
Unit
A
Reset Value
0.0
Example
CURR:MIN 0.0