ITech IT6500C Series

TraceRelated Command(IT6500C)
Copyright© Itech Electronics Co., Ltd. 106
Chapter16 TraceRelated Command(IT6500
C)
In the sub-system, this command is used to configure and control data save in
cache.
TRACe:CLEar
This command is used to clear reading cache. If cache is not cleared,
subsequent saving will overwrite the previous data.
Command syntax
TRACe:CLEar
Arguments
NONE
Example
TRAC:CLE
TRACe:POINts
This command is used to specify cache size.
Command syntax
TRACe:POINts <2 to 2500|MINimum|MAXimum|DEFault>
Arguments
2 to 2500|MINimum|MAXimum|DEFault
Returns
NR1
Example
TRAC:POIN 10
Query syntax
TRACe:POINts? [MINimum|MAXimum|DEFault]
Returns
<NR1>
TRACe:FEED:CONTrol
This command is used to select cache control. Select NEVer, Save to Cache is
disabled; select NEXT, save process starts and will stop when the cache is
filled in. Select ALWays. After cache is filled in, circulate the cache.