jcb Mini CX - Page 286

Section E - Hydraulics
Drive Motors
Wheel Drive Motors
E-116 E-116
9803-9340-8
6 Discard the ‘O’ ring (027) from the valving cover (041)
K Fig 50. ( T E-116).
865970B
Fig 50.
7 Discard the ‘O’ ring (027) from the bearing support
(071) K Fig 51. ( T E-116).
865970C
Fig 51.
8 Position the bearing support under a press on a
suitable support to prevent force on the wheel studs
K Fig 52. ( T E-116).
865970D
Fig 52.
9 Using a mandrel and press, apply a force of 20,000N
(4,496lbf) on the roller bearings then remove the snap
ring (077)
K Fig 53. ( T E-116).
865980A
Fig 53.
10 Release the press and remove the mandrel. Remove
the thrust ring and shims (075). Note the quantity and
order of the shims
K Fig 54. ( T E-116).
865980B
Fig 54.
ðîé
ðìï
ðîé
ðéï
ðéé
ðéë