jcb Mini CX - Page 287

Section E - Hydraulics
Drive Motors
Wheel Drive Motors
E-117 E-117
9803-9340-8
11 Fix a suitable contact plate to the bearing support
K Fig 55. ( T E-117).
865980C
Fig 55.
12 Position the contact plate on supports under the
press. Allow sufficient room underneath for the shaft
to be pressed out. Place some pliant material e.g.
wood, underneath to cushion the fall of the shaft
K Fig 56. ( T E-117).
865980D
Fig 56.
13 Press out the shaft. It may be necessary to apply a
little heat to the inner bearing race although this will
destroy the bearing
K Fig 57. ( T E-117).
865990A
Fig 57.
14 Remove the inner race from the bearing
K Fig 58. ( T E-117).
865990B
Fig 58.
15 Extract the outer bearing race using a two legged
puller
K Fig 59. ( T E-117).
865990C
Fig 59.
16 Press out the seal assembly (072) taking care not to
damage the seal housing K Fig 60. ( T E-117).
865990D
Fig 60.
17 Remove and discard the seal assembly (072)
K Fig 61. ( T E-118).
ðéìòî
ðéî