jcb Mini CX - Page 288

Section E - Hydraulics
Drive Motors
Wheel Drive Motors
E-118 E-118
9803-9340-8
866000A
Fig 61.
18 Extract the bearing outer race K Fig 62. ( T E-118).
866000B
Fig 62.
19 Destroy the bearing cage by cutting it at four points
above the rollers. Take care not to damage the seal
surface
K Fig 63. ( T E-118).
866000C
Fig 63.
20 Separate the cage using a screwdriver then discard
the cage and rollers
K Fig 64. ( T E-118).
Cut the bearing support (078) with a flat chisel and
extract it using a flat screwdriver.
866000D
Fig 64.
21 Extract the inner race (074) from the bearing. It may
be necessary to apply a little heat to the lip seal which
will then be destroyed
K Fig 65. ( T E-118).
866010A
Fig 65.
Assembly
Check the lip seal contact surface on the shaft, the
condition of the splines and the lip seal contact surface on
the bearing support.
1 Install the lip seal (072) in the bearing support using
the correct mandrel. Take off the spring to assist in
positioning the seal. Check that the seal is properly
positioned in the bottom of its groove
K Fig 66. ( T E-119).
ðéî
ðéí
ðéí
ðéè
ðéì